Life pro tip: If you ever need to remove the beautiful piece of art shown in the post, Dremel with a metal cutting blade to create a flathead screw, then remove it.
I’ve done that. It often works, but you have to be careful not to go too deep, or you’ll just break the compromised screwhead right in two once you start with the flathead.
That’s a fair point, only just enough to get the job done. Otherwise you’ll have to either tap it out or get really creative with JB Weld and half of another screw.
Oh, the heads not quite flush, lemme give it juuuuuuust a bit moreahhhhfuck
Maybe if I just stop, align it perfectly, put more pressure behind it and gently start tuuuAHHHFUCKOFF!!!
Life pro tip: If you ever need to remove the beautiful piece of art shown in the post, Dremel with a metal cutting blade to create a flathead screw, then remove it.
I’ve done that. It often works, but you have to be careful not to go too deep, or you’ll just break the compromised screwhead right in two once you start with the flathead.
That’s a fair point, only just enough to get the job done. Otherwise you’ll have to either tap it out or get really creative with JB Weld and half of another screw.
Snap! Can’t even put a new one in…