cooljimy84

I run snapraid and mergerfs, as the nas storage. Not much changes on my NAS and the stuff I really care about like my pictures and videos are on a small ZFS pool. Both are directly on proxmox, meaning I can just plug them in to another Linux machine and research if it all goes sideways. Its all shared from the host via SMB NFS or for jellyfin and immicher its a moint point for the container

You could also padding out the screwdriver tip or the screw hole. I’ve used sticky tape before, but again if its tight your pretty much out of luck…

Depending how tight it is you could superglue something to it to turn it ?

Looks like a cpu/gpu type power connector. Even if its a standard plug does not mean its a standard pin out ! Craft computing on YouTube had what looked like a standard plug in his server but it had a 12volt and ground switched, so would have caused some real damage

I suspect it completes almost instantly if you agree to it tho ?

Wait that sounds kinda wrong…

Plaster of Paris?

Should be fine, I’m writing to spinning rust, so if I was playing back a movie it could cause a few “dad the tv is buffering again” problems

With arr services try to limit network throughput and disk throughput on them, as if either are maxed out for too long (like moving big linux iso files) it can cause weird timeouts and failures

Another one to have a search for is IPFS.

It always throws me when I see at 1080 movie less than 5gb, then I scroll across and see it’s x265…

Web hosting is free, but the extras are non-optional and cost money LOL

Both devices need the same subnet mask, otherwise only one can see the “extra addresses” but in my opnsense I think I and to add some firewall router between LAN & WG0

So the subnet mask is got from the device handing out dhcp. Not 100% sure but on my android the subnet mash for wireguard is as /24 set on the device and also matching in the wireguard settings in opnsense. Opnsense is very very powerful, I would watch a few videos on YouTube about subneting, wireguard routing & dhcp. Its gonna be quite the learning curve (or could be)

As to why everything has stopped working who knows…

My friendly 2 pence, my mobile provider me a 10.x.x.x IP with CNAT (carrier grade NAT) when I’m on mobile data.

Could you not set your subnet mask on the wireguard and home to 255.255.0.0 then you can see the whole 10.0.x.x block in a broadcast?

• my core ratio is 44
• VDDCR cpu 1.288 (manual)
• VDDCR SOC 1.35 (manual)

Very strange, but looks prebent

If I get a change to reboot in to the bios I’ll try and note down my voltage’s

Have a check on what your motherboardois doing in the BIOS. Asus like to by default apply extra boost to give extra performance. I managed to get my 5700G with stock cooler to 4.4ghz all core with less than stock voltages, not sure on temps at the mo as I’m not at home and england is having a bit of a heat wave at the mo (tho I might have won the silicon lotto with my chip)

You look twice as kids and old people aren’t very good judges of speed. Look twice to make sure u’ve not misjudged the speed of the car/bike/trunk/plane/scooter